S E T U P M E N U O P T I O N S
72
channel trim and compensate for speaker sensitivity differences. However, if your receiver does not
have such functions (many receivers do not support channel trim for their multi-channel analog
inputs), you may adjust channel trim through the player. For most accurate results, it is
recommended that you use test tones from a calibration disc, such as
Digital Video Essentials HD
Basics
, and a SPL (Sound Pressure Level) meter. The trim level can be set to +/- 10dB in 0.5dB
increments.
NOTE
Starting from the firmware version BDP9x-52-0707 (released on July 13, 2011), the “
Test
Tone
” can be used in conjunction with the player’s trim control. Each speaker can be set to
independent trim levels and there is no linked pair limitation.
Other Audio Processing Settings
In addition to
Speaker Configuration,
Crossover Frequency
and
Dynamic Range Control
are audio
processing settings that can be configured:
1.
Crossover
: To set the Bass Management kick-in frequency for all speakers. When the speaker
size is set to “
Small
” in “Speaker Configuration” (see page 70), bass information below this
frequency are not passed to the speakers to reduce possible distortion, and if the subwoofer is
available, bass information will be redirected to the subwoofer. The available options are:
x
40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz
– These are
the available crossover frequencies. You can press the
UP/DOWN ARROW
buttons and
the
ENTER
buttons to select it. This option applies to all speakers (center, front, surround,
and surround back speakers). By default the crossover frequency is
80H
z.
2.
Dynamic Range Control
: To set the Dynamic Range Compression (DRC). DRC can smooth out
the sonic peaks and valleys common with wide-range digital audio. Enabling DRC may make low
level audio more audible during low-level listening. Turning off DRC restores the sonic energy
present in the original recording. The available options are:
x
Auto
– Play at the dynamic range specified by the disc. This option applies to Blu-ray
Discs only. For other disc types no dynamic range compression is applied.
x
On
– Turn on dynamic range compression.
x
Off
– Turn off dynamic range compression.
NOTE
The Dynamic Range Compression is applied on the analog audio output, it also works on the
digital audio output (HDMI, Coaxial and Optical) when the audio format is set to PCM.
3.
Output Volume
: To set to enable or disable the analog volume controls (also known as Variable
Audio). The available options are:
x
Variable
– Enable the analog volume control. Use the
VOL-/+
buttons on the remote to
decrease/increase the analog audio output level (the maximum is 100).
x
Fixed
– Disable the analog volume control. The
VOL-/+
buttons on the remote will no
longer affect the analog audio output, and the volume level is fixed to 100.
Summary of Contents for BDP-95
