Opex Sure Sort, Operator'S Manual

Page: 294 / 332

Statistics 147
Sure Sort™ Operator Manual
OPEX Corporation
5.3.1.2. Host Rejects
Back-End
Requested Reject The WMS back-end has requested the ELC reject the
inducted piece.
Back-End Timeout
The WMS back-end did not respond to the ELC's
destination request in the allotted time. The ELC will
reject the piece since it did not receive its location.
Sorter Reject
This is used for the piece database and between the
Host and ELC. In the piece database if you were to
look at the piece, the reject reason (if it originated at
the Host) would be '9' in the ELC reject column, then
whatever the Host reject code was. The ELC uses this
to increment its counts for Host rejects (Host rejects
and ELC rejects are counted separately)
Invalid Destination
Bin The WMS back-end has given the ELC a destination
that is not valid with the configured bin map.
Barcode Not Paired
The barcode sent to the WMS back-end by the ELC
was unable to be paired with a piece.
Piece Lost
The piece was lost within the machine. This is most
commonly due to the iBOT reaching its destination
without a piece on it. Another situation would be if the
operator leaves the Host Run screen while there are
still undelivered pieces in the machine. Leaving the
Run screen closes the connection between the Host
and the ELC, so the ELC is no longer able to track the
pieces and may not get the Host's 'Abandoned at End
of Job' reject reasons.
Reject message Description
Reject message Description
Jamsort
The pieces rejected after a jam condition. The pieces
that are past the imaging sensor when the system
restarts after a jam will be rejected for this reason.