VS-EIU-100X User Manual
Proprietary and Confidential to OpenVox Communication Co.,Ltd
19
Q.SIG Channel Mapping
Sets logical or physical channel mapping. In logical channel mapping, channels
are mapped to 1-30.In physical channel mapping, channels are mapped to 1-
15,17-31,skipping the number used for the data channel, Default is physical.
Enable Caller ID
Whether or not to use caller ID
PRI Dial Plan for Dialed Number
PRI Dialplan: The ISDN-level Type of Number (TON) or numbering plan, used
for the dialed number. Leaving this as ‘unknown’ (the default) works for most
cases. In some very unusual circumstances, you may need to set this
to; ’dynamic’ or ‘redundant’
PRI Dial Plan for Dialing Number
PRI Local Dialplan: Only RARELY used for PRI(sets the calling number’s
numbering plan).In North America, the typical use is sending the 10 digit; caller
ID number and setting the prilocaldialplan to ‘national’ (the default).Only VERY
rarely will you need to change this.
Network Specific Facility (NSF)
Messages
Some switches (AT&T especially) require network specific facility IE. Supported
values are currently ‘none’, ’sdn’, ’megacom’, ’ tollfreemgacom’, ’ account’
Idle Bearer Reset
Whether or not to reset unused B channels
Idle Bearer Reset Period
Sets the time in seconds between restart of unused B channels; defaults to ‘never’
Display Send
Send/receive ISDN display IE options, the display options are a comma separated
list of the following options:
block
: Do not pass display text data.
name_initial
: Use display text in SETUP/CONNECT messages as the party
name.
name_update
: Use display text in other messages (NOTIFY/FACILITY)for
COLP name update.
name
: Combined name_ initial and name_ update options.
text
: Pass any unused display text data as an arbitrary display message during a
call. Sent text goes out in default to ‘name’.
Display Receive
Send/receive ISDN display IE options. The display options are a comma
separated list of the following options:
block
: Do not pass display text data.
name_initial
: Use display text in SETUP/CONNECT messages as the party
name.
bame_update
: Use display text in other messages (NOTIFY/FACILITY)for
COLP name update.
name
: Combined name_ initial and name_ update options.
text
: Pass any unused display text data as an arbitrary display message during a
call. Sent text goes out in default to ‘name’.
Overlap Dialing
Enable overlap dialing mode--sending overlap digits.
Allow Progress When Call Released
Allow inband audio (progress) when a call is DISCONNECT Ted by the end of
a PRI
Out-of-Band Indications
PRI Out of band indications. Enable this to report Busy and congestion on a PRI
using out_ of_ band notification. Inband indication, as used by the gateway
doesn’t seem to work with all telcos.
