B400P/BE400P on DAHDI User Manual
OpenVox Communication Co. LTD.
URL: www.openvox.cn
16
confp->chan.sig = SIG_BRI_PTMP;
confp->pri.nodetype = PRI_NETWORK
3.2 Installation
1
. Hardware detection
# lspci –vvvv
Check the outcome and confirm your system has recognized
B400P/BE400P. If it has been recognized, "ISDN controller" will be
displayed in the output information like that:
02:0a.0 ISDN controller: Cologne Chip Designs GmbH ISDN network Controller
[HFC-4S] (rev 01)
Subsystem: Cologne Chip Designs GmbH HFC-4S [OpenVox B200P /
B400P]
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Interrupt: pin A routed to IRQ 209
Region 0: I/O ports at dff0 [size=8]
Region 1: Memory at feafb000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME+
Kernel driver in use: wcb4xxp
Kernel modules: wcb4xxp
Figure 4 Hardware detection
If B400P/BE400P is not recognized by the system, you have to power off
and take out the card to insert it into another PCI slot.
