CES-8940 User Manual (Iss. 02)
Installation • 2–3
Installing the CES-8940
This section outlines how to install the rear module and the CES-8940 in an openGear frame. You
must install the CES-8940 in an OG3-FR series frame to take advantage of the GigE interface.
Supported Rear Modules
The
8320AR-056
Full Rear Module is required.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “
To install the card in an
openGear frame
” on page 2-4.
To install a rear module in your openGear frame
1.
Locate the card frame slots on the rear of the frame.
2.
To apply a label to your rear module:
• Verify whether your
Rear Module Label
is self-adhesive by checking the back of
the label for a thin wax sheet. You will need to remove this wax sheet before
applying the label in order that the label can be affixed to the rear module surface.
• Affix the supplied
Rear Module Label
to the BNC area of the Rear Module.
3.
Remove the Blank Plate from the slot you have chosen for the installation. If there is no
Blank Plate installed, proceed to the next step.
4.
Seat the bottom of the Rear Module in the
Module Seating Slot
at the base of the
frame’s back plane. (
Figure 2.1
)
Figure 2.1
Rear Module Installation in an OG3-FR Series Frame (Card not shown)
Notice
— Ensure that you install the CES-8940 using the supported rear module listed below.
Installing the CES-8940 with an unsupported rear module can damage the card, the rear
module, or both.
Screw Hole
Module Seating Slots
