iConnectAccess621
Technical Reference
www.opennw.com
26
Wide Area Network (WAN) Setup
Before the router will pass any data between the LAN and WAN interfaces, the WAN side
of the iConnectAccess621 must be configured. Depending on your DSL service provider
or ISP, you will need some (or all) of the information outlined below before you can
properly configure the WAN. The following table lists all DSL requirements:
DSL Requirement
Comment
Line
VPI and VCI
The VPI (Virtual Path Identifier) and the VCI (Virtual
Channel Identifier) define the virtual path settings for the
ADSL connection between you and your ISP. By default,
these settings are pre-configured for 8/35 in your
iConnectAccess621. If you wish to change them, please
ensure you obtain the correct VPI/VCI setting details form
your ISP.
Encapsulation and Multiplexing
For PPPoA, Static, Bridge, DHCP and CLIP authentication
types, you may have to define the encapsulation
parameters. The iConnectAccess621 has two options for
encapsulation: LLC encapsulation and VCMux. The
default encapsulation type for the iConnectAccess621 is
LLC. If you wish to change these settings, please ensure
you obtain the correct encapsulation setting details form
your ISP.
Training Mode
The default is MMODE, and this enables your
iConnectAccess621 to tune into the ADSL services in
Australia automatically. Do not change this parameter.
PPPoA / PPPoE Requirement
Username
Your username is required for authentication for your
Internet service.
Password
Your username is required for authentication for your
Internet service.
Static Type Requirement
DSL Fixed Internet IP Address
Subnet Mask
Default Gateway
Primary DNS IP Address
The iConnectAccess621 supports the following connection types:
PPPoE
PPPoA
Bridged;
Static;
DHCP;
CLIP.
