2
E
ng
lis
h
Directions for use
1. Place food slicer on a flat stable surface.
2. If appliance is being used for the first time, follow Cleaning Instructions.
3. Be sure Switch is ‘off’, then plug into a standard 120V AC electrical outlet.
4. Place a suitable tray or plate behind slicer to collect the sliced food.
5. Place food onto Food Carriage between Support Plate and Slicing Guard. To avoid
danger of injury, always use Food Carriage and Slicing Guard while cutting.
6. Adjust the slice thickness by turning the Thickness Adjustment Knob to desired
thickness (Figure 2).
7. Place the food to be sliced on Food Carriage and slide Food Carriage back so
food is clear of Blade. Slide Safety Lock Tab towards Switch and press Switch
to start the slicer (Figure 2). Grasp the Slicing Guard with the other hand.
8. To begin slicing, push food in towards Pressure Plate with the Slicing Guard as
shown in Figure 3. Slide Food Carriage back and repeat until you have sliced the
desired amount of food.
9. When finished, depress Switch to turn OFF unit. Note: If unit is unplugged
during use the Switch will remain in the ON position when restarting. Always
check that the Switch is in OFF position and always keep hands away from blade.
10. For safety, always return Thickness Adjustment Knob to ‘0’ after use to shield
sharp edge of Blade.
Cleaning Instructions
1. Always unplug the appliance before cleaning.
2. Never immerse the Motor of this appliance in water or other liquid.
3. The Blade, Slicing Guard and Food Carriage can all be hand washed in warm
soapy water. Be careful when cleaning the Blade as it is extremely sharp.
Do not leave blade under water; trying to handle sharp objects in water is
hazardous.
4. Set Thickness Adjustment Knob to “0”.
5. For ease of cleaning, the Food Carriage can be tilted up or removed as
shown in Figure(s) 4.
6. Remove Blade by holding the Blade with one hand and using a coin to unlock
Blade Locking Screw by turning it 1/4 turn clockwise. Carefully pull Blade
off and hold by using the center hole of Blade.
7. Clean outer surfaces with a damp cloth. Mild detergent or plain water
can be used to dampen cloth. Never immerse Motor in water or any other
liquid. Do not use steel wool, abrasive cleaners or sharp utensils.
8. After cleaning and drying, install Blade and Blade Locking Screw to Motor in
reverse order of Step 6 (see Figure 5). Carefully place Blade on mating hub
of Motor Assembly. Align the Locking Screw tabs with the mating slots
in the plastic hub of Motor Assembly and press in until seated. Rotate
Locking Screw 1/4 turn counter-clockwise to lock Blade in place.
