Opal MFP35-1280, Use And Care Manual

Page: 5 / 18

Timer
1. Press “Timer”button to set Automatic Off time while the unit is running.
2. Press “Timer”button to set Automatic On time while the unit is ready.
3. The time can be adjusted within a range of 1 hour to 24 hour. Press the temp up or temp down
buttons, to increase or decrease the time 1 hour by pressing once.
operation
1. The operation is effective when the unit is under mode .
2. Press button in mode, then the unit will work under sleep mode and the up centrifugal fan will
turn to low speed automatically. The set temperature will increase 1°C after one hour, and increase 2°C after 2
hours. After 6 hours, the unit will stop working.
Notice: The main control board has memory function, when the unit is ready to run but in stop status, the main
control board can memorize the initialization of working mode. When you turn on the unit, it will work as the
same enactment of working-mode as last time, no need to reset the working mode again. (this condition is not
available when the unit is under Mode).
Remote controller
The remote controller transmits signals to the system.
How to install batteries
Inserting batteries:
Slide the back cover to open. Be sure the direction is
correct.
1. Open the back cover.
2. Put the batteries inside the slot, with anode
and cathode in right directions
Notice:
1. the anode and cathode of the batteries must be corresponding to the signs of “+” and “-”on the remote
button The appliance will be started when it is energized or will be
stopped when it is in operation, if you press this button.
button Press this button to select operation mode.
button Used to select fan speed in sequence.: or
and buttons Used to adjust the room temperature and the