Connecting Network Cables
The network cable must only be connected to the standard computer connector network jack. DO NOT connect the network cable in any jack other than
the jack intended for that purpose.
See the System Integration document delivered with the system for information about the active port.
Connecting the I/O Loopback Kit
Note: The following procedure is only used for test purposes when no external source is available.
The loopback kit included in the starter kit allows users to test system signals. The connection is made easy with a custom flat cable that matches OPAL-
RT standard DB37 pin assignments.
Connect one end of the flat cable to the loopback board
Connect the loopback board to the simulator DB37 Output signal
Connect the other end (DB37 connector) of the flat cable to the simulator DB37 Input signal
Connect the VUser (required to preserve isolation) from the loopback board to the OP5700