12
13
Igniting your burner
Step 5
Parts required:
Assembled Uuni 3
with Uuni 3 Gas
Burner FSD
Push in and slowly turn the control knob
anticlockwise until you hear a click and the
burner ignites. Continue to push and hold in
the knob for 5 seconds before releasing.
Off
Max. power
Min. power
Click and hold
for 5 seconds
POL gas regulator
This is an anticlockwise threaded
gas fitting. Ensure the tank is fully
turned off and screw the regulator
on to the gas tank valve fitting until
tight.
AUS
•
The appliance must be installed at least 1 meter from any flammable materials.
•
The oven should be placed on a non-flammable, stable and flat surface.
•
Make sure your oven is placed in an area that will not be affected by adverse weather.
•
When the diameter of the injector is 0.83mm use the provided 28mbar regulator with
Propane LPG cylinder.
•
Appliance only to be used with Propane LPG. Minimum cylinder capacity 4kg maximum
cylinder capacity 13kg.
•
Use a suitable provided regulator certified to AS 4621 and a flexible hose certified to AS/
NZ 1869.
•
The length of the hose must be no more than 1.5 meters. Worn or damaged hose must be
replaced. Ensure that the hose is not obstructed, kinked, or in contact with any part of the
oven other than at its connection.
•
The gas supply hose should be checked periodically and should be replaced if damaged
and at least every two years.
•
Check all connections for gas soundness.
•
Your country’s national requirements will advise you how often to replace the hose. Regularly
review these requirements for your country.
•
In the case of blocked venturi immediately turn off burner unit, turn off gas supply,
disconnect gas supply and wait until cooled to removed from oven.
•
Ensure the appliance is clear of debris before every use. If any debris does build up use a
brush to remove this when appliance has cooled.
Gas Safety Information
