Note: There may be noise when pumping the water for the first time, it is normal, the appliance is
releasing the air inside. After about 20s, the noise will disappear.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you preheating the appliance before
making coffee, including the funnel, filter and cup, so that the coffee flavour can not be
influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with desired water, the water level
should not exceed the “MAX” mark in the tank. Then place the tank into the appliance properly.
2. Select the steam mesh, Set steel mesh into metal funnel, make sure the tube on the funnel aligns
with groove in the appliance, then insert the funnel into the appliance from the “Insert” position,
and you can fix them into coffee maker firmly through turn it anticlockwise until it is at the
“Lock” position.
3. Place an espresso cup on removable shelf.
4. Then connect the appliance to power supply. Make sure the steam control knob is on the OFF
position.
5. When you press the power switch“
” once, the power indicator is flashing, the other indicators
are off. After finishing preheating, the power indicator lights solidly. After pressing the coffee
switch,once there is water flowering out you should close the pump immediately.
6. When the lamp in power switch is flashing, the appliance is preheating. When the lamp in power
switch is illuminated, this process is over, you press the coffee switch, and then there will be hot
water flowing out.
MAKE ESPRESSO
1.
Remove the funnel by turning it in clockwise. Add ground coffee steel mesh with measuring
spoon, a spoon ground coffee power can make about a cup of top-grade coffee, then press the
ground coffee powder tightly with the tamper
2.
Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from the “Insert” position, and you can fix
them into coffee maker firmly through turn it anticlockwise until it is at the “Lock” position..
3.
Pour the hot water in the cup, after the cup is warmed up, empty the water in the cup and dry the
cup, and then place the hot cup on removable shelf.
4.
At the time, the lamp in power switch shall be illuminated. If it is flashing, please wait for a
moment. Once the lamp in it is illuminated, you should press the coffee switch, there will be
coffee flowing out. Press the coffee switch again when the required amount is got, and then the
pump stops working.
WARNING:
Do not leave the coffee maker unattended during making the coffee, as you need operate
manually sometimes!
1.After finishing making the coffee, you can take the metal funnel out through turn clockwise, then
pour the coffee residue out with the steel mesh pressed by press bar.
2.Let them cool down completely, then rinse under running water.
