En-
6
If you are using Rocket-
boost™ to wirelessly send
the audio signal to a sub-
woofer, then connect a
subwoofer cable from the
receiver subwoofer pre-
out jack to the UP-TR1
SUBWOOFER IN jack. If
you are not using Rocket-
boost™ with a subwoofer
then this connection
should not be made.
Note:
Every Rocketboost™ network must contain a device called a Hub,
which directs network data traffic and helps devices pair the network.
The network can have only one hub, which is selected using the
Hub
Status
switch on the back of all Rocketboost™ senders. If you are setting
up your network for the first time choose one of your Rocketboost™
senders to be your hub by setting the Hub Status switch to Enable. If
you already have a Rocketboost™ network, then set the
Hub Status
switch on the UP-TR1 to disable. The Status LED lights green for the
Rocketboost™ Hub device, and lights blue for all other Rocketboost™
devices.
To establish communications:
1.
Press the
ON/STANDBY
button on the UP-TR1 to turn it on.
2.
Set the
HUB STATUS
switch to
ENABLE
if the UP-TR1 is to be
used as the network hub, otherwise set to
DISABLE
.
• The ON/STANDBY indicator lights green when the
HUB STATUS
switch is set to
ENABLE
.
• The ON/STANDBY indicator lights blue when the
HUB STATUS
switch is set to
DISABLE
.
Note:
When the
HUB STATUS
is set to
ENABLE
, power remains on
when your receiver is off. When the
HUB STATUS
is set to
DISABLE
,
the power will be off when your receiver is off.
3.
Press and hold the
ON/STANDBY
button on the UP-TR1 for
more than three seconds to put it into pairing mode (it will
remain in pairing mode for 30 seconds). The ON/STANDBY indi-
cator LED starts blinking rapidly.
4.
Press the
ON/STANDBY
button on the sender/receiver device
(the one configured as the hub) for more than three seconds, so
the sender and receiver will enter pairing mode.
• When connected, the ON/STANDBY indicator on both pairing
device and the hub will go solid, indicating the device is now
connected to the network.
• The ON/STANDBY indicator lights steadily if the link is activated
between both of the units.
• The ON/STANDBY indicator blinks at a slower rate if the commu-
nication link is not successful.
Note:
This is only required if you are using Rocketboost™ for your
Zone2, Surround, or Subwoofer audio.
To set up the Sender:
1.
Press the
ON/STANDBY
button on the UP-TR1 to turn it on.
2.
Press the
PORT
input selector on the receiver’s remote control.
3.
Press
SETUP
on the remote control to enter the Source Setup
menu for the UP-TR1.
4.
Press
or
to select
Sender Setup
, then press
ENTER
.
Establishing communications
SUBWOOFER
IN
UP-TR1
Cable not
provided
Setting up the Sender