En-
4
Top panel - UP-TR1
a
ON/STANDBY button
Press to turn the device on, then hold to initiate pairing. Press
again to go to standby.
b
ON/STANDBY indicator
Lights blue when
HUB STATUS
is set to
DISABLE
.
Lights green when
HUB STATUS
is set to
ENABLE
.
Lights steady when the sender/receiver is paired to a network.
Blinks slowly when the sender/receiver is not paired to a network.
Blinks quickly when the sender/receiver is in pairing mode.
c
Standby indicator
Lights red when the sender/receiver is in standby mode.
d
TX1, TX2, TX3 sending mode indicators
Lights blue when the sender setup is
ON
. The indicator that
lights and the receiver’s display show the following.
e
SOURCE button
Press to move to the next receiving source. Each press toggles to
the next source.
f
Rx - Receiver mode indicator
Lights blue when receiving signals.
Back panel - UP-TR1
a
External antenna
Receives signals from other Rocketboost™ senders.
Sends signals to other Rocketboost™ receivers.
b
HUB STATUS switch
Enables/disables hub mode operation. See “Establishing com-
munications” for additional information.
When hub status is enabled, the device is on even when the
receiver is in standby mode.
When hub status is disabled, the device is off when the receiver
is in standby mode.
Note:
In a Rocketboost™ network, only one Rocketboost™ device
should have the Hub Status switch set to ENABLE.
indicator
Receiver’s indicator
Explanation
TX1
TX1(ZONE2)
Zone 2 channels are output
TX1(FRONT)
Front channels are output
TX2
TX2(SB/FH)
Surround Back or Front High chan-
nels are output
TX2(SURRBK)
SurBack channels are output
TX2(SURR)
Surround channels are output
TX2()
No sound is output
1
5 6
23
4
TX3
TX3(SUBW)
Subwoofer channel connected to
the rear panel SUBWOOFER OUT
jack is output
indicator
Receiver’s indicator
Explanation
DISABLE
ENABLE
IN
HUB STATUS
SUBWOOFER
4
1
1
3
2
