Onkyo HTP-993THX User Manual Download Page 3

En-3

Caution

• A mounting screw’s ability to support a 

speaker depends on how well it’s 
anchored to the wall. If you have hollow 
walls, screw each mounting screw into a 
stud. If there are no studs, or the walls 
are solid, use suitable wall anchors. Use 
screws with a head diameter of 9 mm 
(5/16") or less and a shank diameter of 
4 mm (1/8") or less. With hollow walls, 
use a cable/pipe detector to check for any power cables or 
water pipes before making any holes. 

• Leave a gap of between 5 mm (3/16") and 10 mm (7/16") 

between the wall and the base of the screw head, as shown. 
(We recommend that you consult a home installation 
professional.)

The Home Theater means that you can enjoy surround 
sound with a real sense of movement in your own home — 
just like being in a movie theater or concert hall.

.

Speaker Connection Precautions

Read the following before connecting your speakers:
• Turn off your receiver before making any connections.
• Pay close attention to speaker wiring polarity. 

Connect positive (+) terminals to only positive 
(+) terminals, and negative (–) terminals to only 
negative (–) terminals. If the speakers are wired 
incorrectly, the sound will be out of phase and 
will sound unnatural.

• Be careful not to short the positive and negative wires. 

Doing so may damage your amp.

Note

• When you connect the front high left and right speakers, 

prepare for it separately, or use the surround back left and 
right speakers.

Enjoying Home Theater

Wall

 5 to 10 mm
(3/16" to 7/16")

4

3

5

2

1

Corner 
position

1/3 of wall 
position

1

Front left and right speakers (SKF-980) 

They should be positioned facing the listener at about 
ear level, and equally spaced from the TV. Angle them 
inward slightly so as to create a triangle, with the 
listener at the apex.

2

Center speaker (SKC-980) 

Position it close to your TV facing forward at about ear 
level, or at the same height as the front left and right 
speakers.

3

Surround left and right speakers (SKR-980) 

Position them at the sides of the listener, or slightly 
behind, about 60 to 100 cm (2 to 3 feet) above ear 
level. Ideally they should be equally spaced from the 
listener.

4

Surround back left and right speakers (SKB-980: 
HTP-993THX/SKS-HT993THX only)

These speakers further enhance the realism of 
surround sound and improve sound localization 
behind the listener.
Position them behind the listener about 60 to 100 cm 
(2 to 3 feet) above ear level.

5

Subwoofer (SKW-980: North American and Asian 
models/SKW-938: European models) 

The subwoofer handles the bass sounds of the LFE 
(Low-Frequency Effects) channel and bass from the 
satellite speakers when a crossover is specified. The 
volume and quality of the bass output from your 
subwoofer will depend on its position, the shape of 
your listening room, and your listening position. In 
general, a good bass sound can be obtained by 
installing the subwoofer in a front corner, or at one-
third the way along the front wall, as shown.

Connecting the Speakers

Surround back

left speaker *

Surround back
right speaker *

Surround

left speaker

Surround

right speaker

Front left 

speaker

Front right 

speaker

Center speaker

Brown

Tan

Blue

Gray

White

Red

Green

Powered

subwoofer

* HTP-993THX/SKS-HT993THX only

Summary of Contents for HTP-993THX













Reviews: