17
> Settings
|
■
2� Network
•
When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each
components, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway.
Setting Item
Default Value
Setting Details
Wi-Fi
Off(Wired)
Connect the unit to network via wireless LAN
router.
"On": Wireless LAN connection
"Off(Wired)": Wired LAN connection
Wi-Fi Setup
‐
You can configure wireless LAN settings by
pressing ENTER when "Start" is displayed.
Wi-Fi Status
‐
The information of the connected access point will
be displayed.
"SSID": SSID of the connected access point.
"Signal": Signal strength of the connected access
point.
"Status": Status of the connected access point.
MAC Address
‐
This is the MAC address of this unit.
This value is specific to the component and cannot
be changed.
DHCP
Enable
"Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
•
If selecting "Disable", you must set "IP Address",
"Subnet Mask", "Gateway", and "DNS Server"
manually.
IP Address
0.0.0.0
Displays/Sets the IP address.
Subnet Mask
0.0.0.0
Displays/Sets the subnet mask.
Gateway
0.0.0.0
Displays/Sets the gateway.
DNS Server
0.0.0.0
Displays/Sets the primary DNS server.
Proxy URL
‐
Displays/Sets the proxy server URL.
Proxy Port
8080
Displays/Sets the proxy server port number when
you enter "Proxy URL".
Setting Item
Default Value
Setting Details
Friendly Name
Onkyo HT-R695
XXXXXX
Change the device name for this unit which is
shown on other devices connected to the network
to an easily recognized name.
1. Press ENTER to display the Edit screen.
2. Select a character or symbol with the cursors
and press ENTER.
Repeat it to input 31 or less characters.
"A/a": Switches between upper and lower
cases. (Pressing MODE on the remote
controller also toggles between upper and
lower cases.)
"
←
" "
→
": Moves the cursor to the arrow
direction.
" ": Removes a character on the left of the
cursor.
" ": Enters a space.
•
Pressing CLEAR on the remote controller
will remove all the input characters.
3. After inputting, select "OK" with the cursors and
press ENTER.
The input name will be saved.
