Onkyo HT-R358, Instruction Manual

Page: 20 / 72

Turning On & Basic Operations
En-20
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
You can also change the frequency steps (
➔
page 40 ).
Tuning into Radio Stations
■
Auto tuning mode
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
■
Tuning into stations by frequency
You can tune into AM and FM stations directly by entering
the appropriate frequency.
Listening to AM/FM Radio
This section describes the procedure using the buttons
on the front panel unless otherwise specified.
1
Press AM or FM to select either “AM” or “FM”.
In this example, FM has been selected.
(Actual display depends on the country.)
Band Frequency
1
Press TUNING MODE so that the AUTO indicator
lights on the AV receiver’s display.
2
Press TUNING
q
/
w
.
Searching stops when a station is found.
When tuned into a station, the
TUNED indicator
lights. When tuned into a stereo FM station, the FM
STEREO indicator lights as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
• Alternatively, you can use the remote controller’s
TUN
MODE
and
q
/
w
buttons.
FM STEREO
AUTO
TUNED
1
Press TUNING MODE so that the AUTO indicator
goes off on the AV receiver’s display.
2
Press and hold TUNING q / w .
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
Tip
• Alternatively, you can use the remote controller’s TUN
MODE and
q
/
w
buttons.
1
On the remote controller, press TUNER repeatedly
to select “AM” or “FM”, followed by
D.TUN
.
(Actual display depends on the country.)
2 Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8 , 7 , 5 .
If you have entered the wrong number, you can retry
after 8 seconds.