![background image](http://html1.mh-extra.com/html/onkyo/cdr-201a/cdr-201a_operating-instructions-manual_1637817048.webp)
48
If the CDR-201A begins to operate improperly, use the troubleshooting guide below to help you ascertain the problem.
Because the unit contains a microcomputer to provide advanced functions, it may malfunction due to external
noise or static electricity. If this happens, disconnect the power cord and then plug it in again after about 5 seconds.
If it still does not operate properly, press and hold the STANDBY/ON button until the standby indicator and
display turn off (approx. 5 seconds).
About the self-diagnosis function
The CDR-201A is equipped with a self-diagnosis function. If a malfunction is detected during operation, one
of the messages given below will appear in the front display.
Display
Cause
Remedy
Disc Error
•
Playback was likely stopped due to dirt,
•
Eject the disc and check for dirt, dust,
dust, scratches, or vibrations.
and scratches.
•
The disc has been placed in
•
Eject the disc and check that it is placed
upside down.
in correctly.
If you place the disc correctly and the same
message appears, unplug the power cord and
plug it back in again. If the same message
appears again, contact an Onkyo service
representative.
System Err.
A malfunction has occurred in the system
Unplug the power cord and plug it back in again.
(flashing)
due to excessive noise or static electricity.
If the same message appears again, contact an
Onkyo service representative.
Mecha Error
Mechanical malfunction has occurred.
Remove the disc and check it for damage. If the disc
cannot be removed, disconnect the power cord and
then reconnect it. If the same message appears,
contact an Onkyo Service Station.
Rec Error
Malfunction occurred during recording.
Eject the disc and check for dirt, dust, and scratches.
OPC Error
Malfunction occurred during the OPC (
*
1) process.
Eject the disc and check for dirt, dust, and scratches.
If there is a problem with the disc, replace it with one
suitable for recording.
Troubleshooting guide
Messages during recording
Display
Cause
Remedy
Cannot Copy
The input digital signal contains
Record an analog signal or recordable
a copy guard signal (SCMS).
music signal (see page 26).
D. In Unlock
•
The digital input is blocked.
•
Verify that the player component is
properly playing and the digital cable is
properly connected (see page 17).
•
Data has been input in the
•
Verify that source signal is a normal
CD-ROM, etc.
music signal (see page 18).
Rec Setup
The CDR-201A is entering the
Wait until the message disappears.
recording standby state.
Disc Full
Either the disc is full of recordings or
Use a new disc.
99 tracks have been recorded and no
more recordings can be made on the disc.
Pro Disc
A CD-R or a CD-RW not for music recording use
Eject the disc and check whether it meets the
(without the "FOR CONSUMER" marking)
specifications for use with the CDR-201A. Always
or a CD-RW has been inserted.
insert a disc that has the markings "FOR CONSUMER"
or "FOR MUSIC USE ONLY" on its surface
(see page 13).