![background image](http://html1.mh-extra.com/html/onkyo/cdr-201a/cdr-201a_operating-instructions-manual_1637817027.webp)
27
Operations
Digital recording
AUDIO CD RECORDER
DISPLAY
STANDBY / ON
STANDBY
INPUT
CD
DUBBING
REC
FINALIZE
EDIT / NO YES
PUSH TO ENTER
MULTI JOG
CDR-201A
STANDBY/ ON
OPEN / CLOSE
RANDOM MEMORY REPEAT
NAME
ABC
DEF
2
3
1
SCROLL
GHI
MNO
J K L
4
5
6
CLEAR
DISPLAY
ENTER
PQRS
TUV
W XYZ
10/0
>10
7
8
9
REC
RC-448C
o
REC
s
INPUT
EDIT/NO
n
YES
o
REC
2
Start playback of the recording source.
3
Press the
o
REC button (or the remote
controller REC
o
button).
The level sync function is set to ON.
"Rec setup" appears in the display followed by
the time display (the recording standby state).
Note:
Verify to which digital input the optical digital
cable is connected.
Perform digital recording to record the signal input
to the optical digital input terminal of the CDR-
201A. The track numbers are recorded as is from the
input source. The recording level can be adjusted
manually.
Types of digital source that can be recorded
The CDR-201A contains an internal sampling rate
converter, and therefore can record digital signals of
the sampling rates given below.
• 44.1 kHz (CDs, etc.)
• 32 kHz (DAT, satellite broadcasts, etc.)
• 48 kHz (DAT, satellite broadcasts, etc.)
Notes:
• When performing digital recording with an
HDCD, use the procedure given on this page or
that given for signal synchronous recording or
synchronous recording. Also, make sure the
recording level is set to 0 decibels (see page 24).
Since the recording level is set automatically
(DLA) during CD dubbing with the CD dubbing
button, the recording will not be performed
properly.
• You cannot perform digital recording from a
DTS CD.
Preparation
• Turn on the CDR-201A (see page 20).
• Place a recordable CD-R or CD-RW in the CDR-
201A (see page 20).
• Verify that the input dial and recording selection
button of the amplifier are set to the position of
the recording source.
INPUT
or
1
Repeatedly press the INPUT button
until "Digital In1" or "Digital In2"
appears.
Note:
If you select the digital input to which the optical
digital cable is not connected, "D.In Unlock" will
appear.
Proceed to step 6 if you do not wish to adjust
the recording level.
REC
CDR-201A
RC-448C
Proceed to step 3 if you do not wish to adjust
the recording level
REC