Onkyo BD-SP353, Operating Instructions Manual

Page: 36 / 312

36
Additional information
Cautions on use
Chapter 6
Moving the player
If you need to move this unit, first remove the
disc if there’s one loaded, and close the disc
tray. Next, press z (ON/STANDBY) to switch
the power to standby, checking that the
POWER OFF indication on the front panel
display goes off. Wait at least 10 seconds.
Lastly, disconnect the power cord.Never lift or
move the unit during playback — discs rotate
at a high speed and may be damaged.
Place of installation
Select a stable place near the TV and AV
system to which the unit is connected.Do not
place the player on top of a TV or color
monitor. Keep it away from cassette decks or
other components easily affected by
magnetism.Avoid the following types of places:
• Places exposed to direct sunlight
• Humid or poorly ventilated places
• Extremely hot or cold places
• Places subject to vibration
• Places in which there is much dust or
cigarette smoke
• Places exposed to soot, steam or heat (in
kitchens, etc.)
* Do not place objects on top
Do not place objects on top of the player.
* Do not obstruct the ventilation holes
Do not use the player on a shaggy rug, bed, or
sofa, and do not cover the player with a cloth,
etc. Doing so will prevent heat dissipation and
could lead to damage.
* Keep away from heat
Do not place the player on top of an amplifier
or other device generating heat. When
installing in a rack, to avoid the heat generated
by the amplifier and other devices, place it on
a shelf below the amplifier whenever possible.
Turn the power off when not using the
player
Depending on the conditions of the TV
broadcast signals, striped patterns may
appear on the screen when the TV is turned
on while the player’s power is turned on. This
is not a malfunction with the player or TV. If
this happens, turn the player’s power off. In
the same way, noise may be heard in the
sound of a radio.
About Condensation
If the player is moved suddenly from a cold
place into a warm room (in winter, for
example) or if the temperature in the room in
which the player is installed rises suddenly
due to a heater, etc., water droplets
(condensation) may form inside (on operating
parts and the lens). When condensation is
present, the player will not operate properly
and playback is not possible. Let the player
stand at room temperature for 1 or 2 hours
with the power turned on (the time depends on
the extent of condensation). The water
droplets will dissipate and playback will
become possible.Condensation can also occur
in the summer if the player is exposed to the
direct wind from an air-conditioner. If this
happens, move the player to a different place.
Cleaning the player
Normally, wipe the player with a soft cloth. For
tough dirt, apply some neutral detergent
diluted in 5 to 6 parts water to a soft cloth,
wring out thoroughly, wipe off the dirt, then
wipe again with a dry cloth.
Note that getting alcohol, thinner, benzene or
insecticide on the player could cause the print
and coating to peel off. Also, avoid leaving
rubber or vinyl products in contact with the
player for long periods of time, as this could
damage the cabinet.
When using chemical-impregnated wipes, etc.,
read the wipe’s cautions carefully.Unplug the
power cord from the power outlet when
cleaning the player.
Caution for when the unit is installed in a
rack with a glass door
Do not press the i (OPEN/CLOSE) on the
remote control to open the disc tray while the
glass door is closed. The door will hamper the
movement of the disc tray, and the unit could
be damaged.
SN29402235_BD-SP353_EnFrEsItDeNlSv_1510xx.indb 36 2015/10/20 14:36:35