![background image](http://html1.mh-extra.com/html/onkyo/247414/247414_instruction-manual_1637081107.webp)
107
≫
≫
≫
≫
≫
≫
ZONE B function
Cannot ZONE B-output the audio of externally connected AV components
•
To output audio to ZONE B, set the audio output destination to "ZONE A+B" or "ZONE B".
(
)
Remote Controller
•
Make sure that the batteries are inserted with the correct polarity.
•
Insert new batteries. Do not mix different types of batteries, or old and new batteries.
•
Make sure that the sensor of the main unit is not subjected to direct sunlight or inverter-type fluorescent lights. Relocate it if necessary.
•
If the main unit is installed in a rack or cabinet with colored-glass doors, or if the doors are closed, the remote controller may not work normally.
Display
The display does not light up
•
When the Dimmer function is working, the display may go dim. Press the DIMMER button, and change the brightness level of the display.
(
Others
Strange noise can be heard from the unit
•
If you have connected another device to the same outlet as this unit, strange noise may occur under the influence of the device. If the symptom is
remedied by removing the power plug of the other device from the outlet, use different outlets for this unit and the device.
The message "Noise Error" appears during AccuEQ Room Calibration
•
This can be caused by a malfunction in your speaker unit. Check the speaker output, etc.
The measurement results of AccuEQ Room Calibration show different distances to the speakers from
the actual ones
•
Depending on the speakers you are using, some errors may occur in the measurement results. If this is the case, make the settings in
"2. Speaker" - "Distance" in the Setup menu.
(
)
The measurement results of AccuEQ Room Calibration show that the volume level of the subwoofer
has been corrected to the lower limit
•
The volume level correction of the subwoofer may not have been completed. Lower the volume of the subwoofer before AccuEQ Room
Calibration measurement.