1)
Position the hose cage on the motor head mak-
ing sure the power cord is through the raised loop
at the bottom of the cage.
2)
Lift the holdown clamps up over the bottom wire
of the hose cage and snap down the clamps.
Hose &
Swivel
Connector
The hose and swivel connector are pre-
assembled at the factory. To attach the
swivel connector to intake fitting on the
vacuum tank:
1)
Line up the swivel connector slots with
retaining rivets on the intake.
2)
Insert swivel connector and twist clock-
wise until rivets reset against slot end.
Wand
Assembly
1)
Align the button lock of upper wand
section with the opening for the button
lock in the lower wand section and push
sections together.
2)
Slide free end of hose into the grooved
end of upper wand.
T
ool
Installation
1)
Turn wand nut counterclockwise
approximately (4) complete turns. Insert
the tool into wand nut and coupling.
2)
While holding tool in place, turn nut
clockwise until wand nut is fully locked.
The filter shaker is designed to keep the cloth fil-
ter from clogging. When loss of suction occurs or
every 30 minutes you need to use the filter shak-
er.
1)
Turn
OFF
the vacuum.
2)
Agitate the shaker by pushing down on top of
the knobs 3 or 4 times. Extreme pressure is not
required.
Note:
After using the filter shaker if loss of suc-
tion still occurs, empty the vacuum tank.
Filter
Shaker
Knob
P
P
A
AG
GE
E
5
5
O
PERATION
O
F
F
ILTER
S
HAKER
H
OSE
C
AGE
I
NSTALLATION
H
OSE
& T
OOL
A
SSEMBLY
