Oneida Air Systems Mini-Gorilla, Owner'S Manual

Page: 10 / 24

8 Oneida Air Systems
Assembly Instructions
Push three Carriage Bolts (C9H) through the
inside wall of the fan housing section of the
molded cone. Thread the top hole of the Legs
(C8) over the bolt and secure with a 1/4" Flat
Washer (C9I) and 1/4" Whiz-Lock Nut (C9J).
Finger tighten. [FIG. 1]
Note: The top of the leg is indicated by a hole
located 3.5" from the end. The bolt’s square shank
must go through the round housing hole. For
ease of assembly, tighten the nut on the carriage
bolt without the washer - this will pull the square
shank through the round housing hole. Once the
carriage bolt is fed through the leg's hole, remove
the nut. Secure in place with the washer and nut.
1
Secure each Leg (C8) to the threaded inserts on
the lid using three 5/16" Flat Washers (C9L) and
three 5/16" x 2" Hex Head Bolts (C9K). [FIG.
2a] Secure Stem Casters (C9G) to the threaded
insert on the bottom of the legs. Finger tighten.
[FIG. 2b]
Note: For ease of assembly, we recommend
channel lock pliers to tighten the casters.
2
FIG. 1
G
G
SECTI G G
DETAIL
SCALE 1 : 1
G
G
SECTI G G
DETAIL
SCALE 1 : 1
G
G
I
SECTI G G
DETAIL I
SCALE 1 : 1
G
G
I
SECTI G G
DETAIL I
SCALE 1 : 1
C8
C8
C9J C9I C9H
C9K C9L
FIG. 2a
C9G
C8 C8 C8
C9G C9G
FIG. 2b