Oneida Air Systems BenchTop DC, Owner'S Manual

Page: 8 / 20

Oneida Air Systems, Inc. 6
Assembly Instructions
FIG. 1a
FIG. 1b
FIG. 1c
FIG. 2
1
Install the Cork Strips (I, J) to the BenchTop
DC Assembly (A):
a. Turn the BenchTop DC Assembly (A)
upside down [FIG. 1a]. Clean and dry the
bottom thoroughly.
b. Align the 24" Cork Strip (I) along the front
edge of the BenchTop DC Assembly as
shown in [FIG. 1b]. Peel the backer tape off
and adhere to the BenchTop DC Assembly
(A)
c. Align the 1-1/2" Cork Strips (J) along the
left and right edge of the BenchTop DC
Assembly as shown in [FIG. 1C]. Peel the
backer tape off and adhere both pieces to
the BenchTop DC Assembly (A). Turn the
unit right-side up.
Note: Press each piece firmly onto the bracket to
ensure a long-lasting seal.
2
Insert the Top Vane (G) between the Frame
Assembly (E) and Pre-Filter (D) as shown
in [FIG. 2]. The Top Vane will be held in
place by the Pre-Filter pressing on it until the
remaining Vanes are installed.

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE
IS COMPLETELY ASSEMBLED. PLEASE ALSO MAKE SURE THAT YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.