Oneida Air Systems BenchTop DC, Owner'S Manual

Page: 10 / 20

RESET
OFF
RESET
OFF
RESET
OFF
Oneida Air Systems, Inc. 8
Assembly Instructions (Continued)
FIG. 4
FIG. 6
FIG. 5a FIG. 5b
4
Plug the female end of the AC Cord (K) into
the BenchTop DC Assembly (A) male port.
Make certain that the power switch is in the
off position and then plug the AC Cord into an
AC power source (wall outlet) [FIG. 4].
Note: We recommended that you work close
to the front of the unit to ensure the best dust
collection possible. This unit is not meant to
replace other source collection devices, such
as built in dust ports or bags. It is meant to
supplement those tools and create a cleaner zone
of air around the user.
5
Press the switch to the RESET position [FIG.
5a]. The fan speed can be adjusted as needed
using the knob below the switch [FIG. 5b].
6
Tools can be plugged into the accessory port
and should not exceed 10 amps [FIG. 6].
Note: Tools plugged into the accessory port will
remain powered on even when the BenchTop
DC's power switch is in the OFF position.

THIS MACHINE MUST HAVE A GROUND PRONG IN THE PLUG TO HELP ENSURE THAT IT IS GROUNDED. DO
NOT REMOVE GROUND PRONG FROM PLUG TO FIT INTO A TWO-PRONGED OUTLET! IF THE PLUG WILL
NOT FIT THE OUTLET, HAVE THE PROPER OUTLET INSTALLED BY A QUALIFIED ELECTRICIAN.
OFF