13
EN
KEYS AND OPERATION
Keys
• POWER - On / Off
• SETUP - Settings
•
ENTER - Confirm
Setup
Open the battery compartment and insert 4 AAA batteries. Observe the
correct polarity. Close the battery compartment and press POWER. The unit
will start in normal mode. To turn off, press and hold POWER for 3 seconds. To
start the simulation mode, press and hold POWER for 5 seconds with the unit
off.
Note
: To exit the simulation, turn the unit off. If there is no signal for 5
minutes, -- will be displayed and the device will switch off automatically.
Settings
Press and hold SETUP for 3 seconds. The sensitivity indicator will flash. You
can now set the sensitivity. Press SETUP repeatedly to switch between the
various settings. Press ENTER to make settings. If you have not pressed a key
for 5 minutes, the unit will switch to normal mode.
To change units
Press SETUP and ENTER at the
same time and hold for more than
5 seconds. Now press SETUP to
change units from metres = M to
feet = F. If you have not pressed
a key for 5 minutes, the unit will
switch to normal mode.
