oneConcept 10029373, Manual

Page: 33 / 136

33
Insert batteries into the thermo-hygrometer transmitter
Remove the battery door on the back of the sensor by removing the set screw, as shown:
BEFORE inserting the batteries, locate the dip switches on the inside
cover of the lid of thetransmitter. Figure displays all four switches in the
OFF position (factory default setting). The station supports up to eight
transmitters. To set each channel number (the default is Channel 1),
change Dip Switches 1, 2 and 3, as referenced in Table 1. Temperature
Units of Measure: To change the transmitter display units of measure
(°F vs. °C), change Dip Switch 4, as referenced in Table 1:
1 2 3 4 Function
Down Down Down --- Channel 1
Down Down Up --- Channel 2
Down Up Down --- Channel 3
Down Up Up --- Channel 4
Up Down Down --- Channel 5
Up Down Up --- Channel 6
Up Up Down --- Channel 7
Up Up Up --- Channel 8
--- --- --- Down °F
--- --- --- Up °C
Insert two AAA batteries. After inserting the batteries, the remote sensor LED indicator will
light for 4 seconds, and then flash once per 60 seconds thereafter. Each time it flashes, the
sensor is transmitting data.
Down