OneAccess ONE100D/M, Installation Manual

Page: 57 / 67

ONE100D/M Chapter 6
Installation Guide Installing the ONE100D/M
57
6.3 Mounting the ONE100D/M on a wall
Procedure
The backpanel of the ONE100D/M has 2 notches in order to enable wall mounting. Refer to the figure
below, for the position of these notches. By installing two screws at the required distance, the router can
be hung on any vertical surface.
In order to do so, proceed as follows:
Step Action
1 Drill two holes in the wall, according to the following specifications:
• hole diameter: 4 mm
• distance between the holes: 244 mm
• hole depth: at least 25 mm
2 Insert two wall plugs in the holes. The plugs should have the following dimensions:
• diameter: 4 mm
• length: 20 mm
3 Turn two screws in the plugs. Leave a distance of 5 mm between the wall and the head
of the screw.
4 Slide the ONE100D/M over the screws until it touches the wall, and gently push it down.
If necessary, adjust the screws in the notches of the router.