One Stop Systems EB16-SX8, User Manual

Page: 49 / 80

One Stop Systems
ExpressBox 16 Smart | 49
4.12 Power Supply Indicator LEDs
If the LED stays Orange after replacing or swapping the faulty component, you have to reset the SNMP to factory default settings. Hold the
Alarm Reset button (see picture below) until the LEDs blink. The color of the entire LEDs will turn orange and the device will reboot to its
default settings, all LEDs should turn on solid Green
.
4.13
Reset System to Default Parameters
If the chassis is not working properly or having issue accessing the IP address, you have the option of resetting the entire system. There are two
methods on resetting the EB16 system to default parameters.
1. By pressing and holding the “Alarm Reset” button.
2. By flashing the Netburner.
If your unit does not reset by pressing the ““Alarm Reset” button, apply the 2
nd
method, which is flashing the Netburner.
4.14 Pressing and holding the “Alarm Reset” button
1. Power down the unit.
2. Press and hold the Alarm Reset button (shown in the above diagram) for 8 to 10 second or until the LEDs blink.
3. The color of the LEDs will turn orange. This will enable the entire device to reboot to its default settings. You can only do this once
the chassis is turned off, but still operates on standby power. So, ensure the power cable is connected between the chassis and the
AC outlet.