SKU 98158
For technical questions, please call 1-800-444-3353.
Page 6
B - temporary installation method
You may choose to assemble the Gas
1.
Lamp so that it can be moved as need-
ed.
Remove Hex Caps (H) by turning coun-
2.
terclockwise. Set them aside.
Disassemble the following compo-
3.
nents: Propane Housing Container (G),
Base Covering (J) Base (K), Nuts (I),
Washers (N), Anchor Bolts (W) and
Concrete Anchor Bolts (M). Set these
aside for future use.
Place the 3 Washers (N) onto the An-
4.
chor Bolts (W).
Slide the Anchor Bolts (W), with Wash-
5.
ers (N) installed, through the holes in
Base (K).
Install the Base Covering (J) onto the
6.
Anchor Bolts (W) and Base (K) sub as-
sembly.
Securely tighten this sub assembly
7.
together using the 3 Hex Nuts (I).
The Gas Lamp must be electrically
8.
grounded in accordance with local
codes or, in absence of local codes,
with the National Electrical Code, ANSI
/ NFPA 70.
assembling the Bottom Pole
and Propane Housing container
Turn these parts upside down for as-
1.
sembly, as shown in the middle illustra-
tion of the Assembly Diagram.
Align the screws located on the bottom
2.
of Bottom Pole (F) with the holes in the
top of the Propane Housing Container
(G).
Slide Small Washer (Q), Lock Washer
3.
(P) and Nut (O) onto each screw and
tighten securely using the supplied
Wrench (R).
Turn the Propane Housing Container
4.
(G) and Bottom Pole (F) right side up.
Align the holes on the bottom of the
5.
Propane Housing Container (G) with
the Anchor Bolts (M or W) protruding
through the Base Covering (J).
Slide the Propane Housing Container
6.
(G) over the Anchor Bolts (M or W).
Re-install and securely the Hex Cap
Nuts (H).
installing the Gas Line
WARNING: Inspect the Gas Line (T)
1.
carefully before installation to be sure it
is not damaged. A damaged Gas Line
may leak causing possibility of explo-
sion or other injury.
Remove the 4 Screws (V) on the Back
2.
Plate (U) by turning them counterclock-
wise. Set the Screws and Back Plate
aside for future use.
Thread the Gas Line (T) through the
3.
Propane Housing Container (G) and
Bottom Pole (F).
Slide the Middle Pole (E) over the Gas
4.
Line (T). Screw the Middle Pole clock-
wise into the Bottom Pole (F). Tighten
securely.
attaching the Head
You may need assistance to complete
1.
this operation. If help is not available,
it will be easier to complete this opera-
tion by laying the entire assembly on its
side on a work table.
Thread the end of the Gas Line (T)
2.
through the opening in the bottom of
the Head (D).