Setting a source option
When a video source button is pressed like
T
,
f
or another source button on
beo4, a source option sets which input socket on
the TV will actually be accessed.
The beo4 source selection buttons
d
f
*1
T
*1
a
or
c
can each
be programmed to open for a specific input
socket on the TV.
Programming is done by entering a 5 digit code:
1
Press the source button. i.e.
T
2
Press
Or
3
Select source to select. See source table.
4
Select source TX mode.
1: Control TV when source is selected.
2: Control another B&O source.
Source option examples:
VMEM no new source, hereafter TV control
T Or01
VMEM no new source, hereafter beolink TX
T Or02
VMEM opens source “1”, hereafter TV control
T Or11
VMEM opens source “7”, hereafter beolink TX
T Or72
*1
VMEM is the same button as VTAPE on older beo4.
DTV is the same button as SAT on older beo4.
DVD is the same as DVR on older beo4.
Available source table.
These sources are available:
0
Do not change source
1
HDMI 1
2
HDMI 2
3
HDMI 3
4
HDMI 4
5
Video 1
6
Video 2
7
Video 3
8
Component 1
9
Component 2
Not all TV are equipped with all these sources,
and they may be named differently in the
documentation to the TV.
Source TX mode.
Sometimes it is required to release conversion of
beolink data to the TV, when a external source
is selected. If the external device itself is
controllable with beolink data.
Every source selection option is programmed
with its own TX mode option. This sets the
mode to transmit after a new source is selected.
Source selection modes:
1
Data will now be converted to control
TV, until next source selection.
2
Data will now be transmitted as non
converted beolink, until next source select.
Page 4
Installation guide
Oneremote Interface Type 4369
Sony flat screen TV
RM-ED009/ RM-ED010/ RM-ED010/ RM-ED011/ RM-ED012/ RM-ED013
inter
face m
odules that allow thir
d par
ty equipm
ent to
be oper
ated via a Bam
g & Oluf
sen
re
mote contr
ol
system
.
made in the EU by
www.oneremote.dk
Type 4369i1uk
