background image

15

16

TROUBLESHOOTING

PROBLEM:

LED

(red light) does not blink when you press a key.

SOLUTION:

Replace batteries with two new AAA alkaline batteries.

PROBLEM:

LED

blinks when you press a key, but home entertain-

ment device does not respond.

SOLUTION:

Make sure the remote control is aimed at your home 
entertainment device and is not farther than 15 feet 
away.

PROBLEM:

The unit does not control home entertainment devices
or commands are not working properly.

SOLUTION:

Try all listed codes for the device brands being set up.
Make sure they can be operated with an infrared remote 
control.

PROBLEM:

Changing channels does not work.

SOLUTION:

If original remote required pressing ENTER or SELECT to 
change channels,press 

ENTER

or 

SELECT

on this remote after 

entering the channel number.

PROBLEM:

Tried Searching For Your Code method and still could not
find a working code.

SOLUTION:

Clear the device key as follows: Press and hold 

SET

until 

the 

LED

(red light) blinks twice, then release. Next enter 

9

9

2

. Then press the device key to be cleared twice.

Now repeat the Searching For Your Code method on page 
9.

PROBLEM:

CH + 

and 

CH -

do not work for your RCA TV.

SOLUTION:

Due to RCA design (1983-1987), only the original 
remote control will operate these functions.

PROBLEM:

No remote control of volume.

SOLUTION:

See Changing Volume Lock on page 12 to lock/unlock 
volume.

For assistance, please contact us in any of the following ways:

E-mail: [email protected]

Internet: http://www.oneforall.com

Consumer Help Line: (330) 405-8612

INSTRUCTIONS TO THE USER

This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide a reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase separation between equipment and receiver.

• Connect equipment into an outlet or a circuit different from that to which the

receiver is connected.

• Consult dealer or experienced radio/TV technician for help.

LIFETIME WARRANTY

One For ALL ("OFA") warrants this product to be free from defects in materials
and workmanship, under normal use, throughout the period of the product’s
ownership by the original purchaser. This warranty does not cover damages or
failures caused by products or services not supplied by OFA, or which result from
accident, misuses, abuse, neglect, mishandling, misapplication, faulty installation,
set-up adjustment, improper maintenance, alteration, maladjustment of con-
sumer controls, modifications, commercial use, or that is attributable to acts of
God.

There are no express warranties except as listed above. OFA SHALL NOT BE
LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING
FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF
WARRANTY,ALL EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE,ARE LIMITED TO THE WARRANTY PERIOD SET FORTH ABOVE.

Some states do not allow the exclusion or limitation of incidental or consequen-
tial damagers, or limitations on how long an implied warranty lasts, so the above
exclusions or limitations may not apply to you. This warranty gives you specific
legal rights and you may also have other rights which vary from state to state.

To obtain warranty service for a defective product, please return the product,
preferably in the original carton, along with your purchase receipt, to the store of
original purchase for the first 90 days.A note detailing the complaint would be
helpful. The store, at its option, will replace or repair this product if found to be
defective.

If the unit has been purchased more than 90 days ago, please return it to CT
Global Inc. 2305 Hurstbourne Village Dr. Suite 1000 Louisville, KY 40299 USA
together with the original receipt and $3.95 to cover postage and handling. It will
be repaired or replaced at the manufacturer’s option. The manufacturer reserves
the right to substitute a currently manufactured model with equal or superior
features.

One For All: (330) 405-8655

URC-3220

01/06

WALRB3P manual booklet  5/2/06  3:13 PM  Page 15

Summary of Contents for ONE FOR ALL URC3220










Reviews: