ONE FITNESS H7444, Manual Instruction

Page: 13 / 35

13
ASSEMBLY INSTRUCTION
Step 1
Install cylindrical bases (2) for front (3) for
rear to the main frame (1)
Notice that the front base (2) has wheels for
moving your OrbiTrac.
For each base, use two carriage bolts (46)
and two acorn nuts (47). (See Fig.1)
Steps 2 through 4 describe the assembly for the pedals and coupler bars. Once assembly for one side is
complete, repeat these steps for the other side before you proceed to attach the handle bars. Notice the
coupler bar for each side is different (4 for right side, % for left side). A coupler is at the correct side of
the OrbiTrac when its horizontal pivot tube, which is welded at the top of the coupler bar, faces to the
rear of the machine as seen from the user. (See Fig.2)
Step 2
Insert a handle bar shaft (12A)
through the coupler bar of right
and left both side and frame.
The handle bar shaft shown in
page 3.
Then put D sharp washer and
spring washer on both side and
Tighten the hingle screw.
The hingle screw shown in page
4.
Step 3
As with step 2, insert a pedal hinge bolt (12B) through the pedal tubing (6R for right side, 6K for left
side). The pedal hinge bolt, unlike (12A), does not have a groove at the end. Attach the hinge bolt to the
crankshaft (27), which is already installed within the main frame. Again, use WD40 or Vaseline to reduce
firction when necessary. Secure the hinge bolt at the other end with a M12 spring nut (48) and spring
washer (51). (See Fig.2)