Onan MDKBH Series, Service Manual

Page: 39 / 90

5-2
Right Side Panel
The main panel is secured by 5 screws, 1 near each
corner and 1 near the center. The smaller panel is
secured by 3 screws. Removing these panels pro-
vides access to the engine components on the right
side.
Access Doors
The access doors are latched and the front is lock-
able with a key. The door lintel between them is a
channel secured by 1 screw on the right side and
2 screws on the left.
Front / Left Side Panel Assembly
This panel assembly is secured by 2 screws to the
access door lintel, 4 to the drip pan, 6 on the side
and 1 in back along the top edge, right of the AC out-
let box. Remove this assembly and the access
doors for full access from the top, front and left side.
To remove it, remove the 4 screws that secure the
AC output box, disconnect all wiring at the control
panel and remove the two screws that secure the oil
fill neck to the control panel. This panel assembly
can be pulled forward and removed without having
to disturb connections in the AC output box.
AC Output Box
The AC output box is secured by 4 screws in the
bottom of the box. The genset grounding screw and
standoff insulator are for generator, load and
grounding connections.
Air Intake Duct
The duct is secured to the back by 5 screws and to
the side by 3 screws.
DRIP PAN AND MOUNTING SYSTEM
Front Engine Support Bracket
Torque the 3 bolts that secure the bracket to the en-
gine to 41 lb-ft (55 N-m).
Vibration Isolation Mounts
Two of the three mounts are bolted to the engine-
generator adapter (Figure 5-2) and one to the front
mount. Torque the through bolts and the two mount-
ing bolts to the drip pan to 20 lb-ft (27 N-m).
Generator End Bell Support Bracket
See Figure 5-2. Torque all the bolts to 8 lb-ft
(11 N-m).
Redistribution or publication of this document,
by any means, is strictly prohibited.