LV8548MCSLDGEVB for Brush DC motor
www.onsemi.com
6
Hardware Setup
①
Connect the LV8548MCSLDGEVB
（
Motor Driver Module
）
to the ONBB4AMGEVB
（
Motor Driver
Baseboard
）
. Insert the module into the baseboard, while being careful not to bend the header pins
②
Connect the Arduino/Genuino Micro to the baseboard, as seen in the figure below. The USB connection
port should be labeled on the baseboard ”
USB
” to dictate the orientation of the Arduino
③
Plug in the motor wires (Insulation between 5mm
– 10mm) into the output terminals on the baseboard –
OUT_A/B/C/D. Refer to the table below for motor connectivity:
OUT_A
Motor1
＋
OUT_B
Motor1
－
OUT_C
Motor2
＋
OUT_D
Motor2
－
（
Double check the motor wires, + and -, to ensure correct rotation direction
）
④
Connect the Arduino to a PC using a USB cable.
⑤
Insert the AC Power adapter into the DC Jack on the baseboard. Be sure that a
Center positive type
adapter is being used with an
output voltage of 4-16V.
If using power supply cables, please connect the positive terminal to VCC and the negative terminal to
GND in the CN6 connector.
The power supply ter/- at CN6 are polarity sensitive
.(VCC=+,
GND=-)
How to use the GUI
CN6
CN5
③
⑤
④
②
①
