background image

INSTRUCTION / INSTALLATION SHEET
ev

ō

Q™ 5000 Angled In-Ceiling Speaker

IS-0384 Rev. O

301 Fulling Mill Road, Suite G 
Middletown, PA 17057 
Phone (800) 321-2343 / Fax (717) 702-2546 
www.onqlegrand.com 

©Copyright 2007 by On-Q/Legrand All Rights Reserved. 

Page 2 of 3 

1.  Run x/4 conductor (x=gauge preference) stranded speaker wire from the distribution/volume control 

to the speaker location (pre-wiring). 

 
2.

 

If an On-Q Speaker Pre-Construction Bracket is to be used, skip to 

Step “5

” 

and refer to IS-0243 for detailed instructions. 

 
3. If 

pre-wiring 

without using the On-Q Pre-Construction Speaker 

Brackets, leave 4 to 6 feet of wire at the speaker’s intended location.  
Use a strip of cardboard stapled to the joints/studs with a hole 
through it as a wire place holder for the drywall installers if 
installation of the speakers is intended (

see Figure 3

). 

 
4.

 

After drywall and/or painting is complete, push wire through hole, 
center template over hole, mark with a pencil and cut out with a dry-
wall knife. 

 
5.

 

When using the On-Q Pre-Construction Bracket (

see 

Figure 4

), leave a coil of speaker wire on top of the 

bracket coiled around the speaker mounting hole. There 
are clips on the corner of the bracket to secure the 
speaker wire.  Leave enough speaker wire to be able to 
pull the wire through the bracket and comfortably 
connect the wire to the speaker after the drywall is 
installed. Strip off 3 inches or so of the speaker cable 
jacket to expose the positive and negative insulated 
wires.  Strip 3/8-1/2 inch of insulation off of these 
conductors.

 

 

6.  It is recommended to place insulation behind the 

speaker to provide some damping for the woofer driver.  
This will yield the best possible sound.  On-Q 
recommends using poly-encapsulated insulation such as 
Johns Manville Comfort Therm®.  If a defined, consistent 
sound is desired from the speaker in a space, blocking 
can be installed to yield the ideal cubic footage for the 
driver.  Insulation would then be put in this space during 
speaker installation.  

Refer to blocking chart for 

details. 

 
7.  If installing the speaker in a space with an attic above it is 

recommended that the speaker be boxed in with 1/2 inch 
MDF (medium density fiber board) or plywood with 
insulation installed.  This will provide a defined acoustic 
space and protect the speaker.  The best possible sound 
will be achieved by doing this. 

Refer to the blocking 

chart for details

 

Note: Make sure you are in compliance with local building codes before installing this speaker in 
an attic space. 
 
 

Figure 4

Figure 3 

Blocking
Distance

Reviews: