User Guide: OV1015
16 | OV1015
OPERATION
INFORMATION
INITIALIZATION/RESET
The workstation may need to be initialized/reset after any of the following:
- After assembly
- After disconnection from the power supply
- After any impact on the tray.
To initialize/reset, you will need to move the workstation to the lowest position by holding the DOWN button of
the handswitch until the column reaches the lowest position. Then press the DOWN button again and hold it
pressed for five seconds or until a slight movement of the workstation drops down to the machine zero point
and back up to the operation zero point. Once the tray stops moving, release the DOWN button. If the button
is released too early, this leads to a malfunction of the workstation and you must repeat the reset process.
The upper height position is programmed into the control box. For this reason, only use the control box that
has been provided with the specific table frame.
Under no circumstance should a control box from one
workstation be moved to another.
HANDSWITCH OPERATION
By pressing the UP or DOWN buttons, the workstation will move up or down to the desired position.
Once the desired position is reached, let go of the UP or DOWN button. The tray will stop once it reaches
the lower or upper height position.
OPERATION INFORMATION
