No-protocol Connection
200
ZW User's Manual
OUT IP address setting of the specified socket number <OS command>
Sets the OUT IP address.
<Command format>
<Response format>
Normal processing
When a command was not successfully processed
<Parameter explanation>
Parameter
Description
Socket number
Specifies the socket number of which the serial data is to be output.
1: Socket 1 (fixed at 192.168.250.100)
2: Socket 2
3: Socket 3 (fixed at 192.168.250.100)
4: Socket 4 (fixed at 192.168.250.100)
(*1) Sockets 3 and 4 are not used for serial data output.
(*2) Sockets 1, 3 and 4 are fixed and cannot be set by this command. Note, however, that
OK is returned as the response.
1
O
S
9
2
.
1
6
8
.
2
5
0
1
0
0
.
CR
↑
Space
↑
Space
↑
Socket n
u
m
b
er
O
K
CR
E
R
CR
Summary of Contents for ZW-C1*T
