(22/23)
5. Error Code List
(1) Transmission Between User board and R/W Module
Completion Code
Name
Details
10
Parity error
•
There is a parity error in one of the characters
among the command received.
11
Framing error
•
There is a framing error in one of the characters
among the command received.
12
Overrun error
•
There is an overrun error in one of the characters
among the command received.
14
Format error
•
The command format is not suitable for the
specification
Ex) Command section is not specified; page
specification is incorrect, etc.
18
Frame length error
•
When the receiving frame exceeds 260
characters.
•
When the intervals between the characters being
received exceeded 2 sec.
(2) Transmission Between R/W Module and Tag
Completion Code
Name
Details
70
Transmission
error
•
Noise or other disruption occurred during
communication with Tag and command cannot be
executed properly.
71
Verification error
•
Tag is dated or incapable of being written correctly
for physical reasons.
72
Tag absence error
•
Tag is not present near antenna at time of
command execution.
7A
Address
specification error
•
Page specification is incorrect.
7B
Outside of write
area error
•
There is a Tag in the area where reading is
possible but writing is not.
7D
Write protection
error
•
Write command was executed on a page specified
with write protection.
7F
ID system error
•
The Tag used is not to specification of system.
(3) Hardware problem
Completion Code
Name
Details
7C
Antenna hardware
error
•
There is a hardware problem on the antenna.
