32
Command Format
Section 4-3
Specifying Data Code
Whether the read or write data is treated as an ASCII (or JIS 8) code or HEX
code is specified in a command.
ASCII (JIS 8 Code)
When the data length is specified to be 7 bits by the DIP switch of the ID Con-
troller, ASCII is specified. When the data length is specified to be 8 bits, the
JIS 8 code is specified.
One character of ASCII or JIS 8 code data occupies 1 byte (1 address) of the
Data Carrier memory.
Example of specifying ASCII code:
Data Carrier memory address:
Note For ASCII (JIS 8 code), refer to Appendix A.
Hex Code
One character is treated as a hexadecimal number. Therefore, only numerals
0 through 9 and A to F can be accepted.
Two characters of data occupy 1 byte (1 address) of the Data Carrier memory.
Therefore, specify data in 2-character units (in even numbers) when using a
write command. If an odd number of data is specified by mistake, an error
occurs.
Example of specifying HEX code:
Data Carrier memory address:
Header
First address
Write data
Command
ASCII specification
R/W Head No. specification
(fixed to 1)
W T A 1 0 0 1 0 O M R O N *
Address
0010
0011
0012
0013
0014
"O"
"M"
"R"
"O"
"N"
4
4
5
4
4
F
D
2
F
E
Header
First address
Write data
Command
HEX code specification
R/W Head No. specification
(fixed to 1)
W T H 1 0 0 2 0 1 9 8 8 *
Address
0020
0021
1
8
9
8
1 byte
Summary of Contents for V600 RFID System
