Omron V550-A20, Operation Manual

Page: 20 / 76

6
V550-A20 Operation Manual
Section 2-
6
What to Do After Receiving the V550-A20
When you mount your V550-A20, make sure there is enough space
around the unit for the connections to the accessories needed for your
application. There must also be enough room to allow the V550-A20
and its equipment to stay cool. The minimum space requirements for
the V550-A20 are as follows:
• Overhead - Leave enough room for air flow
• Back - 2.25" for connections
• Sides - Leave enough room for air flow
• Front - Make sure there are no obstructions between the scanner
and the bar code to be scanned during the read cycle
There are many different ways to mount the V550-A20. You can
purchase the following five pieces of equipment from Omron to
mount the V550-A20:
Clips (part # V559-A26F)
There are two mounting clips. They are designed to hold the
V550-A20 in a position so the scan line is parallel to the mounting
surface. Each clip has an oblong slot designed for a #6 mounting
screw. The mounting screws are to be located 2.9 inches apart. The
V550-A20 has grooves on each side. Use these grooves with the
mounting clips as shown below, to mount the V550-A20.
To mount the V550-A20:
Step 1 Fasten one clip to the mounting surface.
Step 2
Slide the grooves on one side of the V550-A20 along
the clip.
Step 3 Place the remaining clip in the grooves on the other
side of the V550-A20.
Step 4 Fasten that clip to the mounting surface. This ensures
a tight mount so the V550-A20 does not have any room
for movement during operation.
2.9"
Mounting The V550-A20 Using Mounting Clips
Lorem Ipsup dolor sit
amet, consectetuer
adipiscing elit sed diam
nonummy nibh
euisimod tincideunt ut
laoreet dolore magan .
You can use any type of
fasteners with these
mounting brackets, as
long as they are compat-
ible with the mounting
surface.