English
7
R5-I
Memory function
The measured and displayed blood pressure and pulse values are auto-
matically stored in the memory.
The memory can store the values of up to 21 measurements.
The values measured for more than 21 times will be automatically stored in
the memory, but the values measured most previously will be erased.
The measured values stored in the memory will not be erased even when
the batteries are replaced.
How to recall previous measured values from the memory
By pushing the memory button, you can recall and display the measured
values from the memory starting from the previous measured value. This
When you push the MEMORY Button "M", if there is any measured value
stored in the memory, M1 indicating the lat-
est memory, the systolic and the diastolic
blood pressures and the pulse are displayed
alternatively.
In order to recall the values measured previ-
ously, push the MEMORY Button "M" again.
If there is no measured value in the memory,
the display shown to the right is indicated
when the MEMORY Button "M" is pushed.
is possible after measurement or directly when device is switched off.
SYS
mmHg
DIA
mmHg
PULSE/min
DATE
/TIME SET
SYS
mmHg
DIA
mmHg
PULSE/min
DATE
/TIME SET
M
SYS
mmHg
DIA
mmHg
PULSE/min
DATE
/TIME SET
M
How to erase the memory
All the measured values stored in the memory can be erased simul-
taneously by operating the Buttons as follows:
While the (
) symbol is displayed, push
the MEMORY "M" and the START Buttons
simultaneously and keep on pushing them.
After two seconds, the display shown to the
right is indicated and the measured values
stored in the memory will be erased.
The presently measured values displayed with the (
) symbol are also
erased.
Because this monitor can store the measured values, you can measure
even while you are out, then recall and use the results after returning
home.
mmHg
SYS
mmHg
DIA
PULSE/min
M
M
7.
8.
9.
