Omron MC-514 with IntelliTemp, Instruction Manual

Page: 5 / 32

TITLE
5
BEFORE USE
• The thermometer will not work unless a lens cover is applied correctly.
• For hygienic use, attach a new lens cover each time.
1) Remove the lens cover.
2) Attach a new lens cover.
Insert the lens cover
until it clicks.
REPLACING LENS COVER
Use Omron lens cover (model MC-505LC).
DIRECTIONS FOR USE AND MEMORY
(1) Push button to turn on. (The display will illuminate for 2 seconds.)
Memory Feature:
(
2) The previous value measured is shown on the display (Memory). For the 2nd
and following measurements, the previous value measured
is shown with “M” symbol (Memory).
Note:
When the unit is used for the first time the “M” symbol is not displayed.
(3) When “°F” or “°C” symbol flashes - insert lens into ear. Gently pull back the ear
lobe before inserting for best results. Tugging on the earlobe provides a direct line
to the eardrum to maximize the accuracy of results.
(4) Listen for ready beep (1 beep); an “O” symbol will appear indicating its reading.
Angle is correct; ready for measurement.
(5) Press button again while unit is placed in the ear, 4 beeps means
measurement is complete.
(6) Remove probe from ear.
(7) Discard used lens cover, and replace with a new one,
so that unit is ready for use again.
(8) If you are going to repeat measurements, wait until “°F” or “°C” flashes.
Note:
- You can measure consecutively up to three times. If you are going to measure more
than this, wait ten minutes, then measure again. This is because the measurement
may be inaccurate due to the probe warmed by body heat.
- The thermometer will automatically turn off about 1 minute after a temperature
has been taken. There is no button to turn the power off manually.