Omron FHV Series, Setup Manual

Page: 20 / 164

Precautions for Correct Use
Installation Location
In order to prevent the product from becoming inoperable or malfunction, and to prevent other adverse
effects to the performance or equipment, please observe the following.
• A location where the ambient temperature does not exceed the rated range (operating: 0 to 40°C,
storage: -25 to 65°C).
• A location where the temperature does not vary sharply (condensation occurs).
• A location where relative temperature does not exceed a range of 35-85%RH.
• A location not exposed to corrosive gases or combustible gases.
• A location not exposed to dust, salt, or metal powder.
• A location not exposed to direct vibration or impact.
• A location not exposed to strong disturbance light (laser light, arc welding light, or ultraviolet light).
• A location not near a heating appliance or exposed to direct sunlight.
• A location not exposed to mist of water, oil, or chemicals or misty atmosphere.
• A location not exposed to strong magnetic/electric fields.
• A location not near a high-voltage device or power device
• A location where rubber quality is not deteriorated.
Power Supply, Connection, and Wiring
• If using a commercially available switching regulator, earth the frame ground terminal.
• If the power supply line has surge, connect a surge absorber according to the operational environ-
ment to use the product.
• After wiring the cables, confirm if the power supply is appropriate, if there is miswiring such as short-
circuit of load, or if the load current is appropriate. Otherwise, the product may be broken due to
miswiring etc.
• Do not put load on the cables and connectors before wiring them.
• Do not turn OFF the power supply while data are being saved in the smart camera. Otherwise, data
on the memory is broken, so the product does not operate normally when started up next time.
• When turning OFF the power, confirm that data have been saved completely before starting opera-
tions.
- When data are saved by operating the sensor controller, the saving process must have been com-
pleted and the following user operations must be possible.
- When data are saved using communication commands, processing of the applicable commands
must have been completed and the busy state is OFF.
• If contacting a terminal or a signal cable inside the connector, use a wrist strap to take antistatic
measures to prevent breakage due to static electricity.
• If removing the microSD card, confirm that data are not being read or written before removing it.
• Do not insert the microSD card inversely, obliquely, or as twisting it.
• While data are being read in or written to the microSD card, the SD ACCESS LED on the Smart
Camera main unit is turned on for a while. Remove the card after confirming that the LED is com-
pletely turned off.
• Except when inserting or removing the microSD card, put the cover of the microSD card inserting
connector and screw it up before using the product.
Precautions for Correct Use
18
FHV Series Smart Camera Setup Manual (Z408-E1)