Omron E3X-NA -, Manual

Page: 14 / 28

14
E3X-NA E3X-NA
■
Mounting the Fiber Unit
Tightening Force
The tightening force applied to the Fiber Unit should be as shown
below.
Use a proper-sized wrench.
Fiber Connection and Disconnection
The E3X-NA Amplifier Unit has a lock button. Connect or discon-
nect the fibers to or from the E3X-NA Amplifier Unit using the
following procedures:
1. Connection
Open the protective cover, insert the fibers according to the
fiber insertion marks on the side of the Amplifier Unit, and
lower the lock button.
2. Disconnection
Remove the protective cover and raise the lock button to pull
out the fiber.
Note: To maintain the fiber properties, confirm that the lock is re-
leased before removing the fiber.
3. Precautions for Fiber Connection/Disconnection
Be sure to lock or unlock the lock button within an ambient
temperature range between
−
10
°
C and 40
°
C.
Cutting Fiber
Insert a fiber into the Fiber Cutter and determine the length of the
fiber to be cut.
Press down the Fiber Cutter in a single stroke to cut the fiber.
The cutting holes cannot be used twice. If the same hole is used
twice, the cutting face of the fiber will be rough and the sensing
distance will be reduced. Always use an unused hole.
Cut a thin fiber as follows:
1. An attachment is temporarily fitted to a thin fiber before ship-
ment.
2. Secure the attachment after adjusting the position of it in the
direction indicated by the arrow.
3. Insert the fiber to be cut into the E39-F4.
4. Finished state (proper cutting state)
Note: Insert the fiber in the direction indicated by the arrow.
Fiber Units Clamping torque
M3/M4 screw 0.78 N·m max.
M6 screw/
6-mm dia. cylinder 0.98 N·m max.
1.5-mm dia.
cylinder 0.2 N·m max.
2-mm dia./3-mm dia.
cylinder 0.29 N·m max.
E32-T12F 5-mm dia.
Teflon model 0.78 N·m max.
E32-D12F 6-mm dia.
Teflon model
E32-T16 0.49 N·m max.
E32-R21 0.59 N·m max.
E32-M21 Up to 5 mm to the tip: 0.49 N·m max.
More than 5 mm from the tip: 0.78 N·m max.
E32-L25A 0.78 N·m max.
E32-T16P
E32-T16PR
E32-T24S
E32-L24L
E32-L25L
E32-T16J
E32-T16JR 0.29 N·m max.
E32-T16W
E32-T16WR 0.3 N·m max.
Retaining screw
(flat head or sunken head)
(M3 max.)
Screw-Mounting Model
Cylindrical Model
Spring mounting clip
Toothed washers
Nuts
(attachment)
Lock button
Fiber
Fiber insertion
mark
10.7 mm
Insertion position
Protective cover
Unlocked
Locked
Temporarily fitted
Thin fiber attachment (E39-F9)
Three holes for
standard fiber
(2.2-mm dia.)
Cutter
(E39-F4)
Two holes for
thin fiber
Approx.
0.5 mm
Insertion direction
Downloaded from Elcodis.com electronic components distributor