E3X-DAC-S
11
Do not use the product in atmospheres or environments that
exceed product ratings.
Fiber Amplifier Unit
●
Designing
Operation after Turning Power ON
The Sensor is ready to detect within 200 ms after the power
supply is turned ON. If the Sensor and load are connected to
separate power supplies, be sure to turn ON the Sensor first.
Time may be required for the degree of match to stabilize after
the power supply is turned ON.
Operation When Turning Power OFF
Output pulses may occur when the power is turned OFF. Turn
OFF the power supply to the load and the load line before
turning OFF the power supply to the Sensor.
●
Mounting
Connecting and Disconnecting Connectors
Mounting Connectors
1. Insert the Master or Slave Connector into the Amplifier Unit
until it clicks into place.
2. Attach the protector seals (provided as accessories) to the
sides of master and slave connectors that are not
connected.
Note: Attach the seals to the sides with grooves.
Removing Connectors
1. Slide the slave Amplifier Unit(s) for which the Connector is
to be removed away from the rest of the group.
2. After the Amplifier Unit(s) has been separated, press down
on the lever on the Connector and remove it. (Do not
attempt to remove Connectors without separating them
from other Amplifier Units first.)
Adding and Removing Fiber Amplifier Units
Adding Fiber Amplifier Units
1. Mount the Amplifier Units one at a time onto the DIN track.
2. Slide the Amplifier Units together, line up the clips, and
press the Amplifier Units together until they click into place.
Removing Fiber Amplifier Units
Slide Amplifier Units away from each other, and remove from
the DIN track one at a time. (Do not attempt to remove
Amplifier Units from the DIN track without separating them
first.)
Mounting the End Plate (PFP-M)
An End Plate should be used if there is a possibility of the
Amplifier Unit moving, e.g., due to vibration.
Precautions for Correct Use
Insert
Seal
Remo
v
e
Le
v
er
Press do
w
n
Note 1. The specifications for ambient temperature will vary according to the
number of Amplifier Unit used together. For details, refer to
Ratings
and Specifications
on
➜
page 3.
2. Always turn OFF the power supply before joining or separating
Amplifier Units.
Click
into place
End Plate
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
