D41G
21
Mounting method
D41G-A2
If there are any differences with the versions these are indicated with notes or additional sketches.
1.
To free mounting holes, unscrew the cover C for the wiring
compartment and open flap A for the manual release.
To be observed:
• For exterior installation: Actuation of manual release (beneath flap
A) with triangular key (included in delivery with safety door switch
D41G)
2.
Mount enclosure of safety door switch D41Gflush with doorpost.
To be observed:
• Screws M6 (not included in delivery with safety door switch D41G)
• Tightening torque for safety door switch: 8 N·m
• Tightening torque for cover screw: 0.7 to 1 N·m (Torx T10)
• Wall thickness of the device: 19 mm
• Washers 6.4-dia (included in delivery with safety door switch
D41G)
• For applications with strong vibrations, please observe a proper
securing of the screws.
3.
Insert sliding blocks (included in delivery with actuator unit D41G-
A2) as shown.
4.
Insert sliding blocks
(included in delivery with actuator unit D41G-A2) as shown.
5.
Fit the actuator unit to the doorpost by means of the spacer F (7.5
mm)
To be observed:
• Actuator unit completely retracted
• Distance between safety door switch and actuator unit or
emergency exit: 7.5 +0.5/-2.5 mm
• Screws M6 (not included in delivery with safety door switch D41G)
• Torque: 8 N·m
• Wall thickness of actuator: 8 mm (see step 11)
• Washers 6.4-dia (included in delivery with D41G-A2)
• For applications with strong vibrations, please observe a proper
securing of the screws.
6.
Mount the cover on the actuator unit
To be observed:
• Actuator unit completely retracted
7.
Fit the door-handle
• Mount the door handle or emergency exit E1 horizontally
• D: for left door
• E: for right door
• G: Hexagonal screw A/F 3 with screw-lock (included in delivery
with D41G-A2)
• For the model with suffix -E1T, attach the included lockout tag (SZ)
at the same position as shown in the figure below, and then attach
the resin ring and handle.
• For outdoor installation without emergency exit continue to step 14
A
C
GN
RD
YE
•
•
•
19
GN
RD
YE
Cover screw
Observe the alignment (notch) of the sliding blocks.
E: Left door
D: Right door
E
D
F
E
G
SZ
D
D
E
G
Mounting outside
Mounting inside
Summary of Contents for D41G
Page 28: ...MEMO 28...