![background image](http://html1.mh-extra.com/html/omron/cobra-350-eplc/cobra-350-eplc_quick-setup-manual_743954010.webp)
1.6 Configuration
NOTE
: If you can use the eMB-40R’s default IP address, then you can skip the ACE
software installation completely.
Installing ACE Software
ACE is used to change the IP address of the robot and for troubleshooting. You install the ACE
software onto your PC from the ACE disk.
NOTE
: You will have to restart the PC after installing ACE software.
Setting the Robot IP Address
Configure the IP address of the Cobra ePLC350 robot using ACE software.
1. Connect the PC and the eMB-40R, either through a shared network or with an Ethernet
cable between them.
2. Start the ACE software.
3. Click the Detect and Configure button, circled in the following figure.
Figure 1-6. Detect and Configure Button
The IP address detection and configuration window will open. The ACE software will show
the IP address of any controllers it detects. See the following figure.
Cobra ePLC350 Quick Setup Guide, 13590-000 Rev D
Page 10 of 14
Summary of Contents for Cobra 350 ePLC
Page 1: ...I592 E 01 Cobra 350 ePLC Robot Quick Setup Guide ...
Page 13: ......