7
．
Serial Communications Connection Procedure
25
7.3.3. Creating the I/O Table
Create the I/O table for PLC.
1
If the operating mode of PLC is
Run Mode or Monitor Mode,
change it to Program Mode by
following the steps below.
(1)Select
Operating Mode -
Program
from the PLC Menu
in CX-Programmer.
(2)The confirmation dialog box
on the right is displayed.
Confirm that there is no
problem, and click
Yes
.
*Refer to
Additional Information
on the previous page for the
settings concerning the dialog
display.
(3)Check that Stop/Program
Mode is displayed on the right
of the PLC model in the
project workspace tree of
CX-Programmer.
2
Select
Edit
-
I/O Table and Unit
Setup
from the PLC Menu in
CX-Programmer.
The PLC IO Table Window is
displayed.
Precautions for Correct Use
The PLC is reset after creating and transferring the I/O table in step 3 and subsequent steps.
Always confirm safety before creating and transferring the I/O table.
Summary of Contents for CJ2H-CPU64 -
Page 81: ...78...
Page 82: ...2016 0616 P652 E1 01...
