15
FUELCHECK
®
PROBE REINSERTION with
(PRESSURE <300 PSI)
Positively ascertain line pressure is less than 300 PSI or 2000 KPA.
1. Make sure probe is fully retracted (safety stop
against bottom of insertion fitting). Install probe
onto Process Insertion Fitting and tighten insertion
fitting to valve. Make sure
Swagelok
nut is hand-
tight.
2. Open valve slowly and fully. Again, carefully check for
leaks and repair as needed.
3. Clean and lubricate exposed probe body with light ma-
chine oil or a grease to avoid damaging o-ring seals.
4. When certain of a no-leak status, attach low-
pressure probe insertion handle to probe. Push
probe into pipeline.
Figure 19
Attach probe
Figure 20
Open valve
Lubricate probe
Figure 21
Insert probe into
pipeline
Summary of Contents for FuelCheck
Page 1: ...F FU UE EL LC CH HE EC CK K...
Page 24: ...23 19 5 11 5 6 0 2 25 2 5 Figure 33 FuelCheck Controller mounting dimensions...
Page 34: ...33...
Page 35: ...34 APPENDICES...
