00027956.DOC, Version 1.0
14/18
Power LED
Power ON/OFF
Battery compartment
AUTO TUNE LED
AUTO TUNE button
VOL (volume)
Audio Input jack
WH
P
-600
HEADPHONES
WH
P
-600
Level Indicators
Power LED
Channel selector
Audio Input jack
DC 12 V jack
TRANSMITTER
N
Level meter
10-fold LED meter of the input signal.
N
POWER indicator
This LED lights to indicate that the transmitter is
receiving an audio signal from your AV equipment.
N
Channel selector
This selector allows you to select a channel. There are 3
channels. (CH1 863.5 MHz, CH2 864 MHz, CH3 864.5
MHz).
N
AUDIO INPUT jack
3.5 mm mini jack. Connect your television set, hi-fi
system or any other audio source via the supplied audio
cable. An adaptor for stereo RCA jacks is also included in
the delivery.
N
DC 12 V jack
Connect the supplied 12 V, 150 mA power unit here. Use
the transmitter only with the supplied OMNITRONIC
power unit. Always disconnect the mains connector when
you wish to change connections or move the device to a
different place.
N
POWER indicator
This LED lights red, when you power on the receiver via
the Power switch. When the battery is going flat, the LED
starts blinking and the device shuts off automatically
within a few minutes.
N
POWER ON/OFF
Switches the power to the headphones ON and OFF.
N
BATTERY COMPARTMENT
Remove the cover to replace discharged batteries.
N
AUTO TUNE LED
This LED lights to indicate that the headphones are
receiving an audio signal from the transmitter.
N
AUTO TUNE (frequency setting)
Press this button to start the Auto Tune function. The
headphones tune in to the signal from the transmitter.
If
reception is subject to interference, change the
transmission channel at the transmitter
and press the
Auto Tune button again.
N
VOL (volume)
This control determines the volume of the headphones.
N
AUDIO INPUT jack
3.5 mm mini jack. For direct connection to your audio
source. If this jack is occupied, the loudness cannot be
controlled via the VOL control.
